Provides high output ignition for any 12V points-equipped car or truck Plated with beautiful show-quality chrome for great looks and extended durability 40,000 volt rating Made in USA

NOTE: Use the proper ballast resistor (1.82 ohms) to prevent premature ignition points failure.

This extension harness allows coils to be remotely mounted easily and efficiently Kit includes: eight (8) 3 ft. long extension harnesses with male plugs, female plug and hardware (to be installed by customer) Cords complete with protective shield Plugs into factory harness and factory coil Weather-tight seal to prevent corrosion Fits LS-1 and LS-6 factory coils

NOTE: Use of Moroso Wire Crimper No. 62268 to terminate weather pack ends recommended.

Fits: LS Series Relocates ignition coils from valve cover Non-magnetic, stainless steel studs used to help prevent potential crossfire from the coils Fits O.E.M. and larger aftermarket coils Use with Moroso Ultra 40 Wire Set No. 73811

Fits: LS Series Hinged to provide quick access to valve cover fasteners Coil pack mounting bracket removes with two fasteners Coils nested toward back of motor to free up area on front of valve cover for breathers, vacuum pump fittings, fill caps, etc. Drivers’ side assembly shown Fits O.E.M. and larger aftermarket coils Use with Moroso Ultra 40 Wire Set No. 73436 Use with Moroso Fabricated Aluminum Valve Cover No. 68355